Network Switches

Think I can get some help with setting up my ZYXEL GS1200-5 so I can start my tunnel usage im  in a hole here no hams around to RF into
any help  i can use not the best in networking an setting up a VLAN. Thanks for any help im using windows 7 on my lap top I have a LOCO M2 which is up to
date on builds. THANKS
Wayne
KA3BQS
 

Some experience with this router model?. I tried to load the .elf and it doesn't support it

I configured the GS105E ver 2 as follows:I used the information provided under SOFTWARE down to NETGEAR SWITCHS number 10.

 https://www.arednmesh.org/content/gs105e-1-lan-3-node-1-wan

I can't connect node A port 1 to the camera on LAN port 2 and I can not see node B on port 3 at all. Nothing is in port 4 node C or WAN on port 5 at this time.

Could someone check to see if this is the correct configuration please?

1 NODE A DtD
2 LAN Camera

i recently purchased the NetGear GS108E V3 and set it up as a 6 LAN 1 Node 1 Wan.  I used the set up that was on the Forum for a GS105E  but made it fit the GS108E.  It is not working.  Does anyone have the setup for this that works?  Thank you

aim is to use an OpenWRT router to support a Bullet or an M900

Hello All ...

I would very much appreciate your views on which switch would be my best choice to make Device to Device connections that can be remotely controlled across the AREDN network to apply PoE to its ports individually.  I would like to have at least 5 ports on the switch.

Hi, 
I have a 5GHz Mikrotik dish and a Ubiquity omni w rocket someone loaned me today. Both are powered by their own PoE injectors. Port 5 on the router has PoE disabled. Previously I had it enabled and worked fine with just the dish.