Possible Bugs

I recently upgraded my hAP Lite to the hAP AC2 so I could take advantage of the 1 gbs ports. As such, I flashed it with the most
recent nightly build (2096-fce9629 ) but kept the same hostname in order to minimize the hassle to my tunnel clients.

Except now, sometimes my hAP shows on the meshmap and sometimes it doesn't. When it does show, it doesn't show any of
the tunnel links and those tunneled don't show on the map either (this part seems obvious).

Using GL.INET GL-AR750 and GL-AR300 My entire network failed.
Using Nightly Build ...2074... I have Tunnels back up on the GL-AR750s, but RF Local Mesh on these devices are still not working.
Is it me or the firmware?

To clarify - I had 3 different hubs (GL-AR750) with tunnels and then 3 different RF Local Mesh networks with GL300s.
It appears the GL-AR750 have lost RF Mesh and the GL300s are essentially useless at this point.

Is this a known issue being worked on or ??

N1ATP Knut

• Mesh RF and LAN Access Point can not both use the same wireless card, review LAN AP settings
• Anyone have any thoughts?   Jim W8ERW

After installing the Factory file (rb.elf) for nightly build 2405 on a MikroTik LHG XL 5 ac (P/N RBLHGG-5acD-XL), the AREDN header shows up as NOCALL without any extension. I expect to see NOCALL-XXX-XXX-XXX. When the Sysuprade file is uploaded to the node, the node accepts the Sysupgrade file and I am able to connect to the node with a browser using the 192.168.1.1 IP address. If I try to save the configuration with a Node Name and Password, I get an error message saying that I have an "invalid Mesh IP address". The Mesh IP Address displayed on the AREDN screen is 10.0.0.0

Hello,
I have two RB952 that mesh perfectly on Channel -4 (2387) 5MHz. Now I got a CPE210. When I configure it identically to the RB952, no nodes will appear in the Mesh. When I configure both devices to Channel 1 with 20MHz bandwidth, it works.
Is there a limitation in the CPE210 device implementation? Or a Bug?
I have: Current Version: 3.22.12.0      Hardware Type: (ath79/generic) (cpe210-v3)
Thanks in advance.
73 Christian  DB9CR

I just noticed this, but it's been ongoing for a while I suppose. Running 3.22.12.0 on a TP-Link CPE510.

I have the CPE510 directly connected to a laptop via ethernet, and my home network is connected to the laptop via wireless: