Possible Bugs

I have a mikrotik basebox 2
I updated the firmware to 3.20.3.1
I can login the AREDN mesh OS with no problem
I  have updated the node name, description, password, and location
When I try to set the channel only 2.412-2.484 are available.
What did I do wrong?
How do I access the non shared HAM band channels?

I am using the following image:

- aredn-3.20.3.1-ath79-ubnt_bullet-m-factory.bin

on an Ubiquiti bullet M2 XM device.

It works fine.

However the top LED (LED 6) does not light.  It is working and flashes while booting, but it does not light during operation.

The device works just fine.

My suspicion is  that there is a bug in the code which thinks there are either 7 or 8 LEDs and it is trying to light a non-existent LED.

thoughts on help for debugging?

Thanks!

The bullet M2 models are capable of providing up to 28 dB of power output.

When working with the bullet M2 XM models the image:

- aredn-3.20.3.1-ath79-ubnt_bullet-m-factory.bin

supports the full 28 dB of power output.

With the bullet M2 XW models the image:

- aredn-3.20.3.1-ath79-ubnt_bullet-m-xw-factory.bin

only supports 25 dB.

This appears to be a possible bug which reduces the power fomr the bullet M2 XW systems by perhaps 1/2.

Anyway to debug what is going on here?

The Tunnel Server page allows you to configure credentials for up to 10 clients, but you cannot enable more than 9 at once. If you try to enable all 10, the 10th one is written to /etc/config/vtun with "option enabled '0'" regardless of the state of the "Enabled?" checkbox.

*** aredn_ar71xx/openwrt/files/www/cgi-bin/ucifunc.pm   Mon Oct 26 15:47:22 2020
--- aredn_ar71xx/openwrt/files/www/cgi-bin/ucifunc.pm.NEW       Sun Mar 14 14:59:56 2021
***************
*** 38,44 ****
  sub uci_get_sectiontype_count()
  {
      my ($config, $stype)=@_;
!     my $cmd=sprintf('uci show %s|egrep %s\.\@%s.*=%s|wc -l',$config,$stype,$stype,$stype);

I uploaded my node KF6IIU-32-13-224 location to the map and it shows my CPE510 as a 2.4 band node instead of a 5.8 band node....

I recently purchased some Rocket M5s and set one up as an omni node covering City Hall (node1). There was an IP address conflict with another node (node2) on the MESH RF WiFi network so I changed the IP address on node1. Now I notice when I poll the link_info on any other node that is DTD connected to node1 (for example, node3) it shows a DTD connection to node 2 instead of node1. It looks like when you change the MESH RF WiFi IP address that it is not changing the IP address on the DTD interface, which it is confusing with a different node.