You are here

Home

Nodes

Your search for "30" gave back 616 results.
Results for Forum Topic

Rocket M5ac

published by Ai6bx on Mon, 09/12/2016 - 01:49
Forums: 
Nodes
Has there been any testing for compatibility with the Rocket M5 ac? 

hap ac lite RB952ui-5ac2nd-us

published by km4eug on Sat, 03/05/2022 - 20:19
Forums: 
Nodes

There is a new form design of the HAP ac lite
 the new case is  black and is not square. does not stack easly. Status lights are not easily seen. 
I have programed up three today and they are working flawless. 
 

Strange LAN connect problem to hAP Lite

published by AH6LE on Sun, 03/13/2022 - 19:15
Forums: 
Nodes

I'm fighting with getting a Lenovo M93P Tiny computer connected to my hAP and it's driving me crazy because the problem makes zero sense to me..

New AREDN Hub Configuration

published by N0MRZ on Sun, 02/27/2022 - 19:23
Forums: 
Nodes
I am hoping to get some feedback on the system we are seriously contemplating purchasing and installing. We need to provide 360 degree coverage on 5.8 GHz to serve as a main hub for our AREDN network. This installation is 263' up a guyed tower in the center of the area we hope to service. We are a self-funded group that can't afford the luxury of the best possible setup, but need to make sure we spend our money wisely and get it right the first time. We have to use a commercial climber to install the system.

Sucessful upgades on airrouter, Bullet, NanoStation Loco

published by wa2ise on Sun, 03/27/2022 - 18:25
Forums: 
Nodes
According to thesupported platform matrix page, it says that my airrouters, bullets and nanostation m9s are AREDN Stable, but, NOT recommended for new deployments.  Might be low memory or non MIMO.  I was running version 3.20.1.0 and figured for a long time I might not be able to run 3.22.1.0 on any of these.

hap with 3 dtd ports

published by km4eug on Sun, 03/27/2022 - 13:24
Forums: 
Nodes
how do i (instructions) to make 3,4,5 DTD ports to use at tower to connect three dishes.  I do not have a managed switch with me to test today 

Terry 
KM4EUG@gmail.com
HS Hotline 6100000416

 

3GHz equipment

published by AE6XE on Mon, 08/05/2019 - 16:50
Forums: 
Nodes
This is a recent dialog a mesh'er purchasing a Rocket M3 device had with StreakWave:

mesh'er:  Can you tell me the status of that device?
Streakware:   not on the ship yet. ...  they might be  updating the  Rocket m3. Oct 20 it has to fall into the  new regulation. 
mesh'er:  What new regulation?
Streakware:  What I was told  in 2020 those units  will have to shut down if there’s military operation going on.

NanoStationloco M5 is not responding (solved)

published by DD4SG on Sat, 12/07/2019 - 17:09
Forums: 
Nodes

Hi Guys

 

today I received my new NanoStationLocoM5. I could not wait, and started to get the AREDN Software on the Device. I chose the aredn-3.19.3.0.ubnt-rocket-m-xw-factory.bin. Now I am not sure if this the right firmware. I searched not the forum because i think this is a special problem

 

I describe my steps.

 

I am using an Ubuntu. I installed the tftp and conetcted to the 192.168.1.20. followed the manual and copied the file. Her e my output :

Nano station m5 bricked on 3.20

published by ki5edt on Fri, 04/03/2020 - 16:37
Forums: 
Nodes

I have a Nanostation m5 that ran AREDN 3.19 fine for nearly 1 year  . So the new software came out last week and I did upgrades to 3 of my 10 various branded nodes and the nanostation m5 NS5N and now it won't boot.
It sits there there with the power light stays solid and the 2 lan ports and the 2nd and 3rd signal lights flash quickly and go out at the same time.
 Any ideas?

Duplicate IP Addresses

published by AF6FB on Fri, 03/22/2019 - 20:53
Forums: 
Nodes
Hello,
I have two nodes that have the same LAN address. One is a Ubiquity NanoStation Loco and the other is a Mikrotik hAP.

I have flushed browser history, DNS, powered down each device and only had one connected at a time. How can I give one of them a different address? I see that I can change the WiFi IP address, I'm a little afraid to as it might conflict with someone else. The LAN addresses I can't change.

I need some direction. Here are some screen shots...

Pages

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer