Nodes

I have done something to the MIKROTIK hAP ac lite so that using a either net cable to a lan port entering localnode.local.mesh:8080 returns "localnode.local.mesh's server address could not be found." I have tried three times to reset the unit using the power off, press reset with power on.
Suggestions please.
Steve KI0KY

Have some Air Routers that won't TFTP flash for some reason.
I've followed the instructions from the site and the pdf file (reset button, tftp.exe -i 192.....) and also tried the tftp2 program I used when doing AR units a couple years ago.
I can ping the units at 192.168.1.20
The programs do seem to be attempting, and the AR 1-3 2-4 lights flash speed slows down as if it's working on something but no go.
tftp.exe gives "error code 0, timeout expired, retries expired", and tftp2 says "unable to get response from the server".

I also found this post :

I'm having trouble installing firmware on a NanoStation loco M5 (XM). What should I try next?

Hi all

I'm just getting started with AREDN (and MESH) so I'm going through growing pains apparently

I have the firmware loaded in my hAP Lite and have NO issues talking to it via one of the LAN ports, using my laptop's browser. But I can't get the hAP Lite to connect up with my home LAN router.

I have 2 NanoStation LOCO M2 with XM chipset. Haven't been able to successfully load V3.21 or earlier versions of AREDN software. Have downgraded to AIrOS v5.6.15 but U-boot program still says BAD for Version and GOOD for memory. Ubinity download site does not have v5.5.11 SIGNED firmware and AirOS won't let me downgrade to unsigned FW. I have also tried going around AirOS using SSH and PuTTY to load the renamed file into the node, but it doesn't like the size of the file for some reason. Wondering if the code is XM.Does anyone have a SIGNED version of 5.5.11 . Any other ideas? Thanks!

I ran across some older 900Mhz equipment which we want to setup for some of our members who are in hard to reach locations due to foliage.  The M900 Nanostation had AirOS 5.2.1(XM) installed  and the rocket M9 had the same version.  Right or wrong I decided to update the AirOS just to see if the equipment could be programmed.  The upgrade to 6.3.6(XM) went well and the nodes are connected as AP and station.  I then tried to use TFTP to load the AREDN software.  The Nanostation will not program.  I remember something about the transition to AirOS 5.6 in the past and I fear I should have trie