Nodes

I just received a PowerBeam M5 (400mm) directly from Ubiquiti and when I power it on it's flashing two green signal LEDs + power LED, and not giving me link.  The UI doc is... well, bleak.  I have no clue what this particular pattern means.  Any hints?  (And more points if you can point me at some real hardware documentation -- something better than the "quick start (l)user guide" that comes with the device and prevails in any Internet search.)

Thanks,
--Dave W6DLK -- sfwem / bam

 

Are the LEDs expected to work right on the RBLHG-2nD-XL at this time? I just set mine up with a nightly build less than 2 weeks ago, and I only get the power and 3rd and 4th rssi LEDs lit (solid). I even played around with /etc/config/system (replicating the configuration hypothesized in /etc/board.json) until I got rssileds to run. I can see the brightness values being updated in /sys/class/leds/rb:green:rssi*, but the actual LEDs don't change. This is with an active mesh connection to another node.

Merry Christmas and Happy New Year

I made a mistake and ordered a Lite Dish Feed 5 (LDF-5acD) not supported,  as opposed to a Lite Dish Feed 5 (LDF-5nD) which is supported. 
I have been told that the 5acD is on the list  for support, I was just wondering when  the 5acD support may become available.
 Thanks
 

Upgrading to latest 3.22.1.0 my 2 nodes:
  1) Mikrotik hAPac
  2) GLiNet AR750
don't have results at wifi scan.
I need linking each other via 2G wifi mesh link.

Any other have same troubles?

73 de Leo IZ5FSA

I recently purchased a few mikrotik boards to start building a local (and not so local) AREDN network. I ran through the first 3 (2x baseboards 1x hap ac lite) without issues. Grabbed the second hAP and it took the .elf without issue, but when I upload the .bin to either via the webUI or via the CLI it won't flash and it reverts back to RouterOS 6.7 something. I've tried with the force and no repartition flags with no avail, anyone else run into this? I've factory reset the RouterOS as well.

Group,

I just picked up a brand new Ubiquity Rocket M2. I have flashed half a dozen of these with zero issues. This is the first one I have done that was brand new. It had a hard time taking the firmware. I think it's uploaded but when I go to http://localnode.local.mesh:8080 the first AREDN screen only comes up for half a second then goes away.