Nodes

Could someone please give me a nightly build filename that will flash over ver 6.2. I have no success to this point. I can't get the UI ver 5.5 method to work either. They always seem to die right at the end of the upload. I have used the TFTP method and Pumpkin. with no success. Is there any thing I'm missing?
Thanks and 73 Dave KR4LU.

After installation of MeshChat, no entry apears under Mesh Status/ Services.
The function can only be called by "http://localnode.local.mesh:8080/meshchat/"

Edit...  Does the RF high green LED signify high tx or rx?

Thanks in advance.

Hank K1DOS/DA1KH

My MikroTik hAP is set up as a WAN WiFi Client and can join my Netgear home router on the 5GHz side to distribute ntp to my nodes - works great.  But it won't join my Samsung S9 cellphone 5GHz hotspot.  Other 5GHz devices have no problem joining this hotspot - any ideas?  Yes, the SSID and WPA2 password are correct.
73, Ian N8IK
 

Hi everyone,
Hope this is where I post this? :-}
Two other people as well as myself have googled and looked everywhere (including this site) on the internet for a confirmation of what firmware this NanoStation M2 US is supposed to work with.
"Loco" is not marked on the box or on any labels inside or out. I opened the unit and I do not see an XM or XW on any chip sets unless it is under the RF shield.
On the flat antenna panel inside is etched:
PS1000102A-KA  7/19
1 94V-0
E169497 1942
11-00129-02

It looks like the newer ubiquiti products are dual band.

It the airMAX Bullet AC Dual-Band Radio supported?

Thanks!