Hardware

Hi,
I can't connect to my bullet. The U test program gives me back an error 11003. Can someone tell me what this means?
I can't seem to use my browser to connect to 192.168.1.20 probably for the same reason.
Any help would be appreciated.
Stan
KR6CV

I haven't seen anything on 900 MHz nodes recently, so I thought I'd start a new thread.

I setup a M900, with AIROS 5.6 to see what the interference looked like.
It looked pretty good.  Noise floor was between -100 and -96 dbm.
I didn't see any strong signals in the band.
So I setup an AP with a 10 MHZ bandwidth and 28 dbm.  (nothing is connected now)
I started to notice some odd behavior from my home automation system which is a "Smartthings" system from Samsung.
I have a dozen sensors and devices and some of them would stop working for a while.

I have a link using a couple of NSM3s, but it needs a bit more oomph.  I'd love to install one of the KP Performance dishes at one end.  But they only sell them in 4 packs and I don't need that many.  Does anyone have a spare one they'd be willing to sell?   

The URL is:  https://www.kpperformance.ca/ubiquiti-m-series-radio-reflector-dish
​
Thanks!

Orv
W6BI

I purchased 3 Bullet M2 HP units off E-Bay.  The are older (Test Date 05/21/11) but in all respects appear to be new and in their original UBNT cartons.  The carton indicates AirOS Ver 3.5.  I've successfully logged into it an the firmware version is "XS2.ar2316.v3.5.4494.091109.1451".  Not surprisingly the UBoot test fails completely (Error: System.IndexOutOfRangeException: Index was outside the bounds of the array.  at aredn.Form1.ParseVersion(String ubString).  I don't see any indication for the board used.
 

Does anyone know if the PicoStation2 not the PicoStation M2 HP will work with AREDN?    It is an older model that is an international Model.  The PicoStation M2 HP has been discontinued and replaced with the UAP-AC-M-US Mesh.  I am not finding the PicoStation M2 HP in stock anywhere.  
I know the bullet M2 does the same thing but I don't need something that large or that powerful.  

I found one place that has the PicoStation2 international model in stock and they are willing to sell to me but I want to make sure it will work first.  

I am looking for nodes, antennas and other mesh equipment for fixed stations.

I am also looking for equipment for use in field and off grid environments.

I am very new to mesh.

What are the correct Set up settings for a node to have internet access for the purpose of the AREDN map?   We have a Pi on the node that sees the internet but for some reason after clicking  "Upload data to AREDN Servers"   I receive the message  :  ERROR  Cannot update map.  Please ensure this node has access to the internet.
Thank you-
Jim, NH6WR

Hi everyone

Please take this as a constructive question, because that is what I intend.  I am enthusiastic about amateur radio mesh technology and its application to public service and emergency communications.  I am deeply grateful for the hard work and creativity of the AREDN team.  I am currently operating a two-node mesh in Charlottesville, VA, and actively seeking sites to expand and enhance the network.  Our county public safety communications folks are excited about the possibilities.

I'm unable to downgrade (from 5.6) to 5.5.10 get "Wrong Firmware version is uploaded. Please upload the correct version and try again."
If I try to upload a nightly build for the XW I get "invalid firmware" error.   

Do I have any options to try this out on this hardware?  


Steve