Hardware

Anyone looked into the Onion Omega2? Interesting device, runs on a version of OpenWRT, small form factor, and all sorts of customization. 

https://onion.io/omega2/ 

Douglas
W7ADD

I have been following the build out of the AREDN net from Orange and San Bernardino Counties for the past 6 months.  Now that Snow Peak has a node pointed East I should be able to find the signal from Snow by setting up my NanoBridge M5 in a location visible from Snow Peak.  I have tried 3 locations and not been able to log onto the mesh.  Likely I am not getting lined up properly with the signal from Snow, but I decided to try a test at home.  I pointed the NanoBridge M5 at a NanoStation M5.  of course the signal is strong between the 2 nodes but still the mesh does not run. 

/sites/default/files/sites/default/files/pictures/user2213/Improved%20AL7MH%20AREDN%20Node_0.pdf

Will this work to add internet, tunneling, and an IP camera to an ARDEN Node?

Have three nanobridge units. All three converted successfully. One with xm v5.3 has expected freq./chan range from 5650 to 5925.

The other two were xm v5.2  Say:" untested hardware report experience". They have a freq range choice from 5180 to 5485 They work as expected as a two station mesh network.

Looking at sysinfo both the v5.3 and v5.2 have identical reports. Can the two v5.2 be brought up to the freq range of the v5.3? Do I need to "report" this some place else? Thanks for any help. 

Hello,

I recently flash 4 NSM365 units with the corresponding AREDN firmware and have two questions:

1. Each of the 4 NSM365 displays the message "Untested Hardware" in a yellow notification bar at the top of the page. 
2. Also, the units will only display 5 GHz channels, not 3 GHz. 

Follow ups:

I have a NanoStation M5 (XW version) connected via its secondary port to port 4 of an AirRouter HP.  The NanoStation shows up as a current neighbor on the AirRouter node.  When I try to access the NanoStation through the current neighbor link, it will not connect.  I get the error "ERR_CONNECTION_REFUSED" from my browser.  Note that I can access the NanoStation if I plug my computer directly into the NanoStation LAN port.  I would appreciate any help you could offer resolving this connection problem.