Nodes

My bullet no longer allows login via the normal PC direct connection.
However, it does allow normal login via another node.
I updated the firmware and it made no difference.
Suggestions of how to fix this?

Bob W8ERD

Hi,
While I had no problems following the printed instruction sheet for the hAP ac lite, another Ham in our group kept running into issues (based on his computer/network setup?)
We referenced a youtube video: https://www.youtube.com/watch?v=HrFvDHgabdo

This guy helped steer us around our issues.

Bruce, N1JGB

I plan to use multiple mesh nodes connected to port 5 of an hap ac lite, through a switch. It is clear that there can be only one dhcp server. In order to be able to play with different mesh node configurations it would be most convenient to run the dhcp server on port 5 of the hap and configure all the mesh nodes as dhcp clients.
I did not find a way to enable a dhcp server on the hap's port 5. Did I miss anything?

Wolfgang DF2SI

per request I have started this as new thread, original post (bottom) and first response are copied below:

Joe, thank you for your response.  the fully qualified domain name yields same error, with Rocket M2 LAN port wired directly to my iMac ethernet RJ45 port, after unplug/close browser/replug/open browser sequence. 

Does anyone have any experience with the Ubiquity LTC Rocket? (SWX-LTURR)
https://store.ui.com/us/en/collections/uisp-wireless-ltu-5-ghz-basestati...

Seems like it could work like any of the already supported PtMP Rockets but not sure.

Thanks
Jeremy KC3UXL
Erie,PA

 

A very experienced ARDEN Operator and I are having a problem getting the firmware to boot after it loads.

I don't know if the MikroTik hAP ac3 has been addressed with an issue. I picked one up. Its setup to mesh with OTA nodes. It will not start working the mesh to other nodes till you his scan wifi.To detect other nodes after a power cycle it will not detect other nodes till you hit wifi scan. Then it works fine to the next reboot. 

Im running the lates nightly build.

Dave
KJ5CMB

I am inquiring if anyone has a recommendation on a 24V DC powered outdoor POE injector to substitute for the Factory AC powered 24v injector? (TPLink CPE510 The objective would be to make the CPE510 mast/pole mounted and ultimately powered by Solar powered battery backup without the availability of AC power. I have been using this node as an Outdoor RF node since 9/23 but I am using the AC powered POE injector with weatherproof (CAT 8) ethernet cable.

My friend asked me to flash two Mikrotik nodes he purchased. After I set things up to flash, I looked carefully at the name plates and realized he did not order the hAP ac3 or the QRT 5 as he desired. Will either of these devices flash the currently listed ac3 and QRT5 builds??

Thanks,
Walter, kd7dny
 

I am trying to get a demo AREDN network setup here in Central Florida. I had hoped to get this operational for demo on Field day. I setup a system about five years ago but couldn't get much interest going. I didn't have any big problems in flashing the nodes and had  IP phone and HD PTZ camera links. I have been struggling for the past month in getting nodes to flash. I was able to get a pair of TP Link CPE210 nodes flashed via the PHAROS application. I have tried this on the CPE710 but it gives an unsupportred hardware error. I have also tried PXE but it doesn't load the BIN file.