You are here

Home

Hardware

Your search for "28" gave back 1043 results.
Results for Forum Topic

PoE Switch Recommendations

published by KD9RBV on Sat, 05/15/2021 - 18:48
Forums: 
Network Switches

Hello! I'm very new to all this. Just got started with AREDN recently and I'm still learning about PoE. I've both a MikroTok hAP and a MiktoTik SXTsq Lite5. I've got them both flash. I've been able to power the SXT from the hAP with pass through power. However I've tried a few PoE switches and none of them work. What should I be looking for in a switch that I can connect to the hAP on port 5 for dtd connections?  I've tried the following and none of them are able to power up the SXT. 
  • TP-Link 5 port TL-SG1005P
  • Netgear GS305P
  • Netgear GS108PEv3

Identifying XM vs XW... after reflash

published by N8NQH on Wed, 08/31/2016 - 09:25
Forums: 
Nodes
Is there a way -without disassembling an AREDN reflashed  Ubiquiti node-  to determine what hardware version is inside (XM or XW)?

I ran into an instance where an existing  Aredn NanoStation M5 node was going to be DTD'd to another node.  I was trying to determine if the Secondary Port (XW) is what I was needing to connect to, or not (XM).   I looked in the AREDN setup screens and couldn't find any "hint" of what hardware circuit board was inside.

Connecting Flashed GL USB 150 to Wi-Fi

published by K2PMD on Sat, 05/29/2021 - 19:03
Forums: 
Nodes
So, I just flashed my new GLi USB 150 and I would like it to connect to the internet. Only my Hap is CAT6 connected to the router and thus getting an internet connection. How do I get my GLi USB 150 (or any node not connected to a router) to connect to my local wi-fi internet? 

Thanks. de K2PMD

SXT Lite 5

published by K6AH on Sun, 02/03/2019 - 00:54
Forums: 
Nodes

Just picked up a MikroTik SXT 5NDR2 (or SXT Lite 5 for short) https://mikrotik.com/product/RBSXT5nDr2  This thing is small!  27dBm and a 16dBi dish that fits in your hand.  Perfect for stealth installations.  I've asked Joe to have a look at it.  Hopefully we'll get support for it.

Andre, K6AH

MODERATOR: edited link

RB912UAG-5HPnD - mini pcie card.

published by kc7dmf on Sun, 05/23/2021 - 09:39
Forums: 
Hardware

Hello,
Does anyone know if the add on mini pcie card is supported with AREDN firmware?
If it is can you do simultaneous 2.3Ghz and 5.8Ghz, or is it just one at a time. 

Mikrotik R11E-2HPND Internal RF Wireless Networking Card
https://www.amazon.com/Mikrotik-4-MikroTik-R11e-2HPnD/dp/B00I4QFCU0/ref=...


73
Mark
KC7DMF

EdgePoint R6 Switch mode VLAN setup help

published by WD6EBY on Wed, 06/09/2021 - 23:52
Forums: 
Network Switches
Hello All,

I have a new UBNT EdgePoint R6 Router that though the Wizard I have setup the unit as a Switch.  Now I am trying to setup vlans between my backbone and the Mesh nodes.  I think I understand how to Tag a vlan to an eth port but cant figure out how to untag or exclude vlan1 from the Mesh ports.  I have this type of vlan configuration working with the UBNT EdgeSwitches but not quite grasping the VLAN setup on the EdgePoint R6 in the Switch configuration.  If anyone has had any experience doing this I would appreciate your assistance.

Thank you.

GS305E

published by AH6LE on Sun, 06/13/2021 - 16:53
Forums: 
Network Switches

I've looked at the various Netgear config pages for how to setup a GS305E switch for deployment at one of my sites. Here is the configuration I'm shooting for:

One PBE400 connected to the Mesh
A 2nd  PBE400 used to allow others to connect in order to access the Mesh
Raspberry Pi (used for Allstar) that uses the Mesh to connect to my other Allstar nodes
Yaesu Fusion repeater to connect to the Mesh


I thought this might be the method to use:

Mikrotik LDF Dish Size

published by KV3T on Tue, 06/22/2021 - 19:00
Forums: 
Antennas
My neighbor was throwing out a 1 meter dish. Is there a practical limit to the dish size for the ldf 5ghz? Or is bigger better? http://nextcloud.caseydiers.com/index.php/s/c8NGbprxxXQ5kGa Also, pressure washing is very cathartic http://nextcloud.caseydiers.com/index.php/s/mzgC9ALK8Dmbw5W

Ubiquiti NanoStation AC Loco

published by KG5AGP on Thu, 05/27/2021 - 11:06
Forums: 
Nodes
Howdy, everyone!
     I am new here to the AREDN mesh group and apparently seem to be the only ham in Northeast Louisiana that looks to be interested (per forum and map). Anyway, I recently acquired a handful of Unifi NanoStation AC Loco devices. Taking a look at the firmware and whatnot they appear to not be XM or XW but rather WA. Has anyone played with these before or are they simply of no use to AREDN? Figured I would ask because 'free' is always better than forking over $$$ especially right now.

Thanks and 73!

de KG5AGP

Support for TP-Link WBS210/510

published by KE0RSX on Tue, 01/01/2019 - 15:10
Forums: 
Nodes
Hi, everyone,

Pages

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer