Hardware

I was given a pair of 900 mHz rockets and yagis that were previously flashed AREDN. I connected them to my hAP and temp turned on WAN so they could download the correct FW (I chose the nightly build). All went smoothly and I can get to all the usual webpages, etc from the LAN. HOWEVER, after flashing both rockets show power LED, ethernet LED (as applicable) and solid RED  LED but neither radio sees the other (they're about 10 ft apart and I turned the power down "just in case". WiFi scan shows nothing either

Does anyone know if a  Ubuqiiti airMAX 5 GHz, 19/20 dBi Sector Antenna AM-5G19-120 will work with a newer Rocket AC Lite R5AC-LITE.? Will the R5AC-LITE slide into the bracket on the back of the sector antenna?  Assume the antenna SMA lines will be the same.
Thanks
Bob
KE6GYD
 

I was at the Hamvention this is year and saw a small WiFi transceiver at the, I think, the AREDN table.  It was about 6" square and the guy said it ran about $65. 
I know this is a sketchy description, but I was wondering if anyone could give me any information.
Thanks,
 

I'm working on setting up an AREDN node, and since the rest of my home network is built on Ubiquiti, it seems like the NanoStation might be the right fit for me. I see that there are two versions, XM and XW, and I need to load the right software based on which version I get.

There's a web page, perhaps older than the current supported devices page, that I was pointed at:
https://www.arednmesh.org/content/supported-platform-matrix

Is 3.22.12.0 the final release for ar71xx devices ( https://downloads.arednmesh.org/releases/3/22/3.22.12.0/targets/ )?  I have a number of Ubiquiti RM5-GPS units that run great on 3.22.12.0, but do not have the ability to be upgraded to the ath79 releases.  I tried many different sysupgrades and factory firmware images of the ath79 releases but no joy.  It's not imperative that they be upgraded, I just finally got a chance to do it.  

Hello everyone,

      I just loaded the new 3.24.6 release onto a TP-Link CPE 220v3 and it is working fine.  Not sure what all has to be done to get the status changed from untested and unsupported to tested and supported, but I'm willing to give the testing a try.  The firmware was available for download, so I decided to give it a try and it has been working fine so far.  I did an upgrade from an older AREDN version; I didn't test the install from factory.

Tom
N4QLM

Hello,

     I see on the supported hardware page some of the entries are listed as supported, but have dashes where the filename is.  The firmware isn't available for download.  Is more firmware coming for the 3.24.6 release?  I'm specifically looking for the Ubiquiti Rocket M5 Titanium TI firmware.  It has 64 MB memory, and I'm willing to do whatever testing is necessary.  Thanks.

Tom
N4QLM

Hello !
I've bought a Ubiquiti PowerBeam 5AC-ISO-Gen2 M400, thinking the radio was the same as other PB, but I'm unable to flash it :-(

I've tryied several firmware, including this one: