You are here

Home

Hardware

Your search for "28" gave back 1043 results.
Results for Forum Topic

Nanostation M2 firmware not updating

published by VE3SKH on Thu, 09/28/2017 - 10:29
Forums: 
Hardware
Hello

New guy question here.

I have a Nanostation M2 that I purchased.  I followed the directions to change the firmware, but nothing worked.

Here is what I have tried:
Original Firmware XW-5.6.12
Tried to downgrade it to XW-5.5.10 
got message "wrong firmware version"
Tried to update to XW-5.6.15 - Success
Tried again to downgrade to XW-5.5.10 - "Wrong Firmware version"

Firmware update failed

published by w8erd on Sat, 05/30/2015 - 11:16
Forums: 
Nodes

I tried to install AREDN firmware on a Bullet M2, which previously had BBHN firmware.

As soon as I clicked on the update button, everything stopped. No messages, now window, nothing.

Now I cannot communicate with the Bullet at all.

What can I do now?

Thanks!    Bob W8ERD

NBE-M2-400

published by W7ADD on Fri, 09/16/2016 - 17:47
Forums: 
Nodes
I have a NBE-M2-400 from another project, any suggestions on giving it a try with AREDN?

Douglas
W7ADD

bricked Nanostation M2

published by kj6dzb on Thu, 08/23/2018 - 01:32
Forums: 
Nodes
Hi All,

I bricked the firmware on a NS M2 downgrade. Dose any one have expertise & willing to take the node and jtag flash it? Im willing to buy you a beer + shipping.


73 Mathison   

newbie questions on vlan switch and bullet

published by wa2ise on Mon, 05/16/2016 - 15:18
Forums: 
Network Switches

Some questions on separating the LAN and the WAN of a bullet, I have a linksys router with OpenWRT on it.
I'm a newbie trying to figure this out.  I figure that this diagram of an ASUS router is valid as describing my OpenWRT Linksys rouyter: Yes?
Looking at this (from the OpenWRT website)

Bullet M5 XM TFTP stops when trying to upload firmware

published by N4RT on Sun, 03/17/2019 - 21:18
Forums: 
Nodes
Need some help to figure out what I'm doing wrong.

I have successfully flashed other M5 devices including those with XW chip sets.  This is a Bullet M5 with XM chip set running AirOS 6.1.9.

I can put the Bullet in TFTP mode with alternating LEDs as expected and I am using the Windows 10 TFTP client to transfer the 3.18.9.0 firmware.  As soon as I hit the enter key after typing in the TFTP command string, the alternating LEDs on the Bullet STOP and it just sits there.

NanoStation 5 firmware installation issues

published by KJ6KIZ on Wed, 03/20/2019 - 01:35
Forums: 
Hardware
I just purchased a nano station 5 and I can't seem to get the Arden software flash to the device. I also don't know how use tftp to install firmware.

NanoBeamM5 19

published by VE7TFM on Sat, 03/23/2019 - 20:00
Forums: 
Nodes

I have a couple NanoBeamM5 19 with v5.5.9(xw)

I would like to use these as Nodes.

The supported hardware matrix points to the ubnt-loco-m-xw firmware.

I tftp the firmware,  it reboots as normal,  log-in to localnode:8080,  set node name and password as usual,  save the changes.

here it goes south.  the node doesn't reboot.  I still get a 192.168.1.24 ip address from the node and it comes back an an un-configured node.

where do I go from here?

Help!

NanoStation Loco M5 (XW)

published by K7CTM on Fri, 03/29/2019 - 01:43
Forums: 
Nodes

After flashing a NanoStation M5 (XW) I was unable to connect to the radio directly via the ethernet, I was able to connect to the radio via wifi. 

I accessed the AREDN setup entered my call, password and Distance.  When I try and save the settings it came back "Configuration not saved.  parameter DTDMAC in file*_setupdefault does not exist".

I'm unsure what to do next.  Any ideas? 

Thomas Robbins - K7CTM




 

Is the 24V/1A PoE sufficient for Rocket M2 and a NanoStation M2?

published by K3GX on Tue, 04/02/2019 - 23:26
Forums: 
Nodes
I would like to use the secondary port on my NanoStation M2 to power a Rocket M2 with the PoE pass through, so I upgraded the PoE supply to the Ubiquiti 24V/1A version rather than the 0.5A version that normally comes with the NanoStation. I just learned that the Rocket is shipped with the 1A version. Does the Rocket take more power than the NanoStation? If so, with the 1A supply power both units at the same time?

Thanks,
Dave K3GX
 

Pages

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer