You are here

3.16.1.1 upgrade failure

3 posts / 0 new
Last post
KQ6EO
3.16.1.1 upgrade failure
I tried to update 3 nodes and they all failed.  One bullet with direct connection, one NanoStation XM OTA, and one NanoStation XW OTA.  They all seemed to upload the new firmware OK and rebooted several times and then the LEDs indicated that they were loaded and ready.  I am sure that I used the correct upgrade bin file for each upload and had the keep config box checked.  None of them would reconnect to the mesh or allow connection over a direct Ethernet cable.  I was able to TFTP the factory bin file to them and reconfigure and they were fine.  No tunnels are setup and I tried the old 3.16.1.0 addresses, 192.168.1.20, and even 192.168.1.1 to connect.

I still have a NanoStation XW and XM still to be upgraded

What do you think I am doing wrong or has this issue shown up elsewhere.

Thanks

Tom
KQ6EO
K5DLQ
K5DLQ's picture
Did they have MeshChat,
Did they have MeshChat, HamChat, or anything else (non-stock) installed on them?
Did they have tunnels installed?  (I know you said that none were setup)
KQ6EO
Nothing but the AREDN
Nothing but the AREDN software is on them, nothing extra loaded.  I have not done anything with tunnels on them at all.

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer