You are here

Ubiquiti NanoStation Loco M900

4 posts / 0 new
Last post
VE3EMY
Ubiquiti NanoStation Loco M900

Hi,
Recently I tuned this device to channel -2 (Frequency 2397). It worked and I was able to join the mesh. So I'm just wondering if there's any downside of this or anybody tried this before?
 

K5DLQ
K5DLQ's picture
huh??  a 900Mhz device tuned

huh??  a 900Mhz device tuned to 2397Mhz???

AE6XE
AE6XE's picture
The 900MHz devices and the 2

The 900MHz devices and the 2.4GHz Ubiquiti devices are the same motherboard, except the 900MHz devices have a down converter added.   I'd speculate we don't have the boardID on this specific device to have the right AREDN firmware settings (it's not yet supported).   If this is the case, then please load AirOS back:

1) using telnet or ssh, login to the device with user = ubnt and password = ubnt at IP address 192.168.1.20 .
2) "cat /etc/board.info" file and copy-paste and post back here.
3) "dmesg" and copy-paste output back here.

Joe AE6XE

K6AH
K6AH's picture
This might also open the

This might also open the possibility for the device to transmit out-of-band.  900 MHz is only 25 MHz wide in the US--that's 5 channels of 5 MHz each and technically only 1 entirely in band at 20 MHz bandwidth.  I can't vouch for other countries.  Please use caution when you see the Unsupported Device banner.

Andre, K6AH

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer