You are here

Home » Forums » Hardware » Nodes

Ubiquiti Bullet M5

4 posts / 0 new
Log in or register to post comments
Last post
Tue, 05/09/2017 - 11:00
#1
kf7nqw
Ubiquiti Bullet M5
I have a Ubiquiti Bullet M5 with stock UBNT firmware. I have a 7dbi omni antenna that I know works. The unit will does not transmit, at least according to my 5.8 GHz-capable tablet. I upgraded to the latest 5.5.x UBNT firmware and I got a signal from it for about 15 seconds then it was gone.

Is the unit bad or flaky? I've had it for some time but this is the first time I've connected it up and tested it. The other question is would putting the Aredn firmware correct the problem?

Thanks in advance.

John
kf7nqw
Top
Tue, 05/09/2017 - 11:49
w6abj
Try turning off airmax, and
Try turning off airmax, and make sure it is in the correct frequency range
Top
Tue, 05/09/2017 - 12:49
(Reply to #2)
K5DLQ
K5DLQ's picture
good point.  AirMax is the
good point.  AirMax is the UBNT TDMA protocol used for UBNT-UBNT connections.
Top
Fri, 05/19/2017 - 11:29
kf7nqw
Thanks for that information
Thanks for that information.That was the problem. Of course if I had flashed it to Aredn, that would have resolved it also but defeated my purpose at this time.

Thanks again.

John
kf7nqw
 
Top

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer