OK, I just got an AirRouter HP and tried to upload the 3.16.1.0 firmware. Checked first with the AREDN U-boot Test and got "Good/Good" since it was running AirOS ver 5.5.6.
Upload went well until it rebooted and now I cannot get to localnode:8080. I have "Obtain IP address automatically" checked in the TCP/IP properties screen. I have rebooted both PC and AirRouter but its not talking.
The software load instructions on this website seem to be written for a nanostation or the like since in the TFTP recovery section it talks about waiting for the Red Link 1 LED to start blinking and I don't have that on the AirRouter. So, how do I get this thing in the "recovery" mode and reload the firmware? I haven't tried any TFTP actions yet because the instructions don't appear to work for the AirRouter.
Are there different instructions somewhere that I missed that apply to the AirRouters only?
Any help would be appreciated.
Thanks & 73,
Ron N4RT
Bromley, AL
Same instructions, just the LED's are different on it, and the other note is make sure your plugged into lan port 1-3 (lan port 4 is for DTDLink only and the WAN port where the power is fed is for internet/wan only)
Thanks for that reminder about the LAN ports... that was exactly my problem! As my luck goes, I had picked port 4 to connect up my PC and, naturally, it didn't work... duh! Put the PC in port 1 and everything's good. Thanks for the help and the reminder about those ports.
73,
Ron