You are here

MikroTik Router BOARD RBLHG-5HPnD

9 posts / 0 new
Last post
AC2OG
AC2OG's picture
MikroTik Router BOARD RBLHG-5HPnD
3 weeks ago I flashed my MikroTik RBLHG-5HPnD with the last firmware version 3.22.12.0 and I experienced some problems as follows:
-casually I can't enter the Node Status of some nodes in the mesh, some others yes. The issue temporarily appears and disappears in selected nodes. 
My RBLHG is the only MikroTik device in the mesh build with 18 nodes. All the others are Ubiquiti Bullet, Power Beam, Rocket.
After re-flashing the node with v. 3.22.8.0  the issue was resolved.
Maybe the dev team is interested in this report.

 
K5DLQ
K5DLQ's picture
is there any pattern of the
is there any pattern of the nodes that you can/cannot access?

Ie.   can get to all RF nodes.   Cannot get to any nodes across a tunnel.   Can get to all DTD nodes.  etc.
 
AC2OG
AC2OG's picture
is there any pattern
I can get to all the nodes except one, but not always the same. It's an RF link, not tunnel, not DtD. Sometimes it is a neighbor, other times it's  2-3 jumps away.
 
AC2OG
AC2OG's picture
Firmware v.3.22.12.0
further to my first post, I also add that with the firmware v. 3.22.12.0 the use of TeamTalk 5 is problematic. There are frequent audio dropouts and video signal freezing.
AC2OG
AC2OG's picture
Firmware v. 3.22.12.0 and MikroTik
After further tests, I confirm that the highlighted problem is specific to the pair: " Firmware 3.22.12.0 and MikroTik device
RBLHG-5HPnD-XL". Perhaps some other user will be able to confirm or deny my remark for the benefit of the development team.
k1ky
k1ky's picture
Firmware v. 3.22.12.0 and MikroTik
What frequency and Bandwidth are you using?  There are known issues with Miktrotik device compatibility using 5MHz bandwidth.  You might want to try the newer "Model Specific" Nightly for the LHGHPXL as well as there may already be some improvements related to your issue.
AC2OG
AC2OG's picture
Firmware v. 3.22.12.0 and MikroTik
Frequency: 5.835 GHz, BW: 10 MHz. I would like to stress the concept that all the problems have been solved by downgrading to  v. 3.22.8.0.
Thanks for the suggestion of  "Model Specific" nightly built versions. 
ng1p
ng1p's picture
Firmware v. 3.22.12.0 and MikroTik

I'm seeing issues also. Posted the below:
https://www.arednmesh.org/content/dns-bug-32212
K7SDW
I made a mistake and 
I made a mistake and  uploaded the "regular' SXT and when I tried to load the High Power into it, I received a no can do, so now can only load the "lite" version.  I have one light and one HP, so I guess the only recourse is to reflash and try the HP nightly again?




 

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer