You are here

RF Mesh Trouble?

10 posts / 0 new
Last post
DF2TH
DF2TH's picture
RF Mesh Trouble?
Hello dear Hams,

I have a phenomenon with several HAP AC and GL 300M nodes.
All devices use the same RF mesh channel and bandwidth.
Oddly enough, only the AC Lite and the GL300M connect to each other.
All nodes are only listed when I connect a GL to a Lan port.
Do I have a configuration error or a mistake in reasoning?

Greetings
Thomas DF2TH
K6CCC
K6CCC's picture
The hAP AC is not supported.

The hAP AC Lite is supported.  The hAP AC is not.  See the supported hardware matrix:  https://www.arednmesh.org/content/supported-platform-matrix
 

DF2TH
DF2TH's picture
Mesh
I use the hap ac lite only
AJ6GZ
Bandwidth?
What freq and bandwidth? The MikroTiks sometimes work on 5Mhz but mostly not.
DF2TH
DF2TH's picture
Mesh
all Nodes are workking on channel -2 2397 MHz with 5MHz Bandwith. all Hap Lite are connected each other and GL-iNet 300 also, but not connection between hap an gl nodes via RF Mesh
nc8q
nc8q's picture
Mikrotiks and 5 MHz bandwidth
At 5 MHz bandwidth, Mikrotiks link with each other, but often not with other manufacturers.
 
DF2TH
DF2TH's picture
thanks a lot for Information
thanks a lot for Information
AB7PA
Hardware defect in known issues list
DF2TH
DF2TH's picture
thanks a lot for Information
thanks a lot for Information
AB7PA
Switch your nodes to 10MHz

Switch your nodes to 10MHz channel width and they should link.

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer