Not sure how to correct other than reflash with older firmware.
I've tried to restart the service without success. Any help will be entertained.
Error is below. It stops all Tunneling in and out.
Problem restarting vtund
Change file from .doc to .jpg in file attachment
Aaron
what firmware version?
What error do you see in the UI?
Sorry.
Latest 3.22.1.0
UI stated 'Problem restarting vtund'
Tried to stop, start and restart via CLI with no luck.
unable to reproduce on 3.22.1.0. I have a live tunnel client. "/etc/init.d/vtund restart" succeeded with no warnings or errors.
Please attach support data file.
Joe AE6XE
File attached here
Reflashed and no error; all connected
KB9MTD, The configuration file of your tunnels does not exist "/etc/config/vtun". Did anything unusual occur when upgrading firmware? The "keep settings" box was checked? What does the tunnel setting pages look like? Most likely to set back up, the only option is in the tunnel setup pages, re-enter the data :( .
I've gone through this process, including tower sites with the 3.22.1.0 release and have not seen any issue with tunnel setup on a Rocket and hap-ac-lite. Unless others report the same issue, something local must have happened. I see your device is an TP-LINK CPE210 v2. Maybe, something unique to this model, but I'd be very surprised.
Regards,
Joe AE6XE
Joe,
Checkbox was auto checked I confirmed it because I was fearful I may loose info in the rewrite. No visible issues when reflashing the first time. Fluke maybe? I've found out at work that sometimes you either just need a power cycle or to simply reload. No worries.
Thanks for your help!
Aaron