Daisy chaining (DtD) nodes and hAP AC Lite

I recently flashed my hAP AC Lite with the AREDN firmware. My configuration is as follows: hAP (port 5) > NSM5 XW > NBM5. Since the flash to AREDN firmware I can only access the hAP and the NSM, I can no longer access the NBM node. It shows up as a neighbor of and DtD linked to the NSM, but when I click the address link it just times out.

I'm guessing my settings are wrong somewhere. Perhaps I need to disable or change DHCP settings on one, two or all of the nodes? Or do I need to use static addressing and/or NAT?

I was able to access both nodes when the hAP was running the stock Mikrotik RouterOS firmware.

I learned early on that I could not daisy chain both these nodes off the hAP and power them with a single PoE device, so the hAP is currently powered off its included psu or a network swtich and the two nodes are powered of a PoE injector.