You are here

Home » Forums » General discussion

SSID Broadcast

9 posts / 0 new
Log in or register to post comments
Last post
Fri, 02/21/2020 - 15:00
#1
k6dlc
k6dlc's picture
SSID Broadcast
   I have noticed with : 1339-105a2ba firmware and earlier that I am not seeing my ssid being broadcast on channel -2. Did something change? I have enabled RF but nothing. Also, I have also notice that on my M2 nodes the signal LED does not change to indicate power output.
 Thank you
Top
Sat, 02/22/2020 - 00:06
AE6XE
AE6XE's picture
K6DLC,   How/Where are you
K6DLC,   How/Where are you looking to see the SSID on ch -2, and not finding it?   Does "enabled RF", mean in basic setup "Mesh RF Enable" is checked?
Top
Sat, 02/22/2020 - 19:21
(Reply to #2)
k6dlc
k6dlc's picture
  I am looking in WIFI scan
  I am looking in WIFI scan and I do not see my other M2 I have MESH RF enable via the basic setup.
 
Top
Sat, 02/22/2020 - 19:29
(Reply to #3)
AE6XE
AE6XE's picture
Also check the channel width
Also check the channel width setting.   If it set at, e.g. 5Mhz channel width, then when you do a wifi scan, only 5Mhz width signals are detected.   wifi scan only sees other signals of the same channel width.

Joe AE6XE
Top
Sun, 02/23/2020 - 13:32
(Reply to #4)
k6dlc
k6dlc's picture
  Three are on the same
  Three are on the same channel, -2 and with the same SSID. All nodes can NOT see each other SSID.
Top
Sat, 02/22/2020 - 19:24
w6bi
w6bi's picture
Configured?
Is your M2 configured?   I believe in unconfigured state the node radio doesn't transmit.

Orv W6BI
 
Top
Sun, 02/23/2020 - 13:31
(Reply to #6)
k6dlc
k6dlc's picture
  What do you mean configured
  What do you mean configured? It is configured wit SSID, -2 channel and 5 MHz. I have two other LOCO M2 with the same information and none of them see each other. I baffle.
Top
Sun, 02/23/2020 - 13:37
(Reply to #7)
AE6XE
AE6XE's picture
Can you upload a support dump
Can you upload a support dump -- link at bottom of Administration page to obtain?   Grab one from each of the 2 nodes that can't see each other in wifi scan.

Joe AE6XE
Top
Sun, 02/23/2020 - 16:05
(Reply to #8)
k6dlc
k6dlc's picture
  I don't know what had

  I don't know what had changed. I can see all my SSID nodes.

Top

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer