You are here

ProCurve 1700-24 switch

5 posts / 0 new
Last post
LA9UI
ProCurve 1700-24 switch

I have tried to use a ProCurve 1700-24 switch with the setup from Understanding VLAN's by K5DLQ. I have 2 NanoStation loco M2 and 2 NanoBridge M5. It seems that I cannot control all the necessary parameters. I use 5 ports on the switch. DtD between a NanoBridge M5 and NanoStation loco M2 is working, but the RF connection between the two NanoBridge M5 is only intermittent.The RF connection between the NanoStations is solid. Can the ProCurve be used successfully with AREDN?

Hans-Petter  LA9UI

K6CCC
K6CCC's picture
Please give us a little more

Please give us a little more detail about your issue.   The ProCurve should be just fine, but what does that have to do with a flaky RF link?

LA9UI
Seems that I need help

Seems that I need help configuring the ProCurve. I cannot find a place to tag or untag specific VLAN's on a port.
VLAN 2, tagged port 2 and 3.
VLAN 1 tagged port 2 and 3, untagged port 5.
VLAN 10 untagged port 1 and 2.

Hans-Petter  LA9UI

K6CCC
K6CCC's picture
Are you using the GUI, the

Are you using the GUI, the menus, or command line to config the Procurve?  I have been configuring HP switches for a decade or so.  Should be able to help.
First of all, you need to enable VLANs.  If you don't enable VLANs, you can't configure them.
 

LA9UI
I use the web browser

I use the web browser interface in the switch. Firmware was VB.02.01, I just upgraded to VB.02.09

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer