You are here

Is the PBE-M5-400-US supported?

7 posts / 0 new
Last post
WB0GXD
Is the PBE-M5-400-US supported?

We are just getting started into the world of mesh networking.  My question is - The airMAX PowerBeam 5 GHz, PBE-M5-400-xx is listed on the supported list, but with an ISO suffix rather than the -US suffix. Is it still supported by the AREDN firmware? Thanks!

nc8q
nc8q's picture
Is the PBE-M5-400-US supported?

As far as I know, yes.
I have a PBE-M5-400 in service.
I do not remember if it had a -US suffix or not.
I'll look for the original box.

Chuck
 

WB0GXD
Is the PBE-M5-400-US supported?

Thanks Chuck.  I guess I'll be finding out as I'll be ordering a pair tomorrow thanks to your feedback.
Paul

nc8q
nc8q's picture
PBE-M5-400 .vs. LHG-5[HP][-XL]

Hi, Paul:
I bought my PBE-M5-400 before there was AREDN firmware for the Mikrotik units.
I find the Mikrotik LHG (and SXTsq) devices to be a little cheaper and much much easier to mount and aim.
Chuck
 

K5DLQ
K5DLQ's picture
the US vs INTL suffix usually

the US vs INTL suffix usually does not matter.

NM7B
My -US works

The PBE-M5-400-US I acquired converted over to AREDN without a hitch.

WB0GXD
Thanks everyone for the

Thanks everyone for the prompt feedback. The PBE-M5-400-US units I ordered will be arriving next week. I'll probably have more questions later. It's good to know that there is a knowledgeable support group here when needed. Thanks again.
-Paul WB0GXD

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer