You are here

Newbie Question on 2nd Node

7 posts / 0 new
Last post
k6ghl
Newbie Question on 2nd Node

Just getting started and I have 1 node up and running.  I now want to add a second node on same pole so that I can get ~240 deg of coverage.  Not sure on how to connect and what configuration settings to change.  Using Ubiuiti NanoStation M2's flashed with AREDN software.  

Thanks in advance for the help.

Greg
K6GHL

w6bi
w6bi's picture
DtD link.

Just connect them together with an Ethernet cable.  They'll broadcast and establish a DtD link across the cable between themselves.

kc8rgo
If these were NSM2s, would

If these were NSM2s, would the cable connect to the secondary ports, or the LAN ports on the POEs?  (either??)

KG6JEI
A note that having the two of
A note that having the two of them on the same RF channel will likely decrease the quality of both links, you may wan to have one set of links on a different RF channel as well.
N8NQH
N8NQH's picture
valid concern

A note that having the two of them on the same RF channel will likely decrease the quality of both links, you may wan to have one set of links on a different RF channel as well.
 

yep.  It's kinda tough to do this on 2.4,  since there's only one "good" channel there.  but 5.8 gives quite a few channels to chose from.

Here is an array I put together:
http://www.tim-yvonne.com/ham/mesh/array/index.htm
 

K5DLQ
K5DLQ's picture
yeah.  The "good" choices are
yeah.  The "good" choices are:
-2 @ 5Mhz
-1 @ 5Mhz
N8NQH
N8NQH's picture
also...
-2 @ 10 is do'able; that's all we use anymore on 2.4

 

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer