Hi!
I am trying to set up a mesh in Northern Norway. I have 2 Nanobridge M5. Installed Aredn 3.19.3 on both, OK. Was setting up with default values. Seems to be working, but the two radios (running barefoot) does not see each other. They are a few meters apart, with low power. Can anyone tell what I am doing wrong?
Hans-Petter LA9UI
The following must be set the same on each node:
Fint å ha en annen norsk ombord. Jeg er fra Drammen.
Andre Hansen, K6AH
Node names LA9UI-1 and LA9UI-2
Channel 149 BW 5MHz
SSID AREDN-5-v3
Firmware 3.19.3.0 configuration mesh
WiFi and LAN addresses are different. No WAN address, no default gateway
So What?
Andre, vet du om andre norske er på mesh??
Hans-Petter LA9UI
Try changing the bandwidth to 10 MHz.
Andre, K6AH
10 MHz works!!!
Is that a bug in 3.19.3.0 ??
Hans-Petter, LA9UI in Tromsø Norway
We see this once in a while. We aren't sure if it's firmware, or nuances of the specific nodes you are using. It would probably be good to set them back to 5 MHz and post the Support Data files from each node. http://localnode.local.mesh:8080/cgi-bin/admin
Andre.K6AH
Here are the support files
Hans-Petter, LA9UI