Morse Micro Halo-1
After Flash and IP 192.168.1.1 the Node is Stuck asking for setup information and reboots and asks for it again.
Not sure what can be down to recover the device.
73's Rich W4NMH
After Flash and IP 192.168.1.1 the Node is Stuck asking for setup information and reboots and asks for it again.
Not sure what can be down to recover the device.
73's Rich W4NMH
There is a users manual for the Halow Link 1 which has a process for recovering from a failed upgrade. Do you want to try that and reflash?
As I recall:
1) remove power
2) push and hold reset button
3) power on
4) hold reset button ~10 second, then release
Should restore factory state.
There are two levels of reset, 1 if you hold for 5 sec, 1 if you hold 10-15 sec. You can tell by the flash pattern of the LEDs.
This worked when I flashed the wrong firmware file the first time.
Carl
Ko4ssa
2. Attach an Ethernet from the HaLowLink 1 directly to your computer.
3. While powered off, press and hold the mode button on the HaLowLink.
4. Attach the power cable and turn on power.
5. Watch for the Status LED to turn yellow, then blink white 5 times.
6. Release the button, the LED should remain yellow.
7. Configure your network connection with the following static IP and netmask: IP address: 192.168.12.2 Netmask: 255.255.255.0
8. Open a web browser on the computer and navigate to http://192.168.12.1
9. Upload a firmware file and press ‘update firmware’.
10. Do not remove the power until the device has installed the firmware and fully booted.
You will see the following LED patterns to show progress:
a. solid purple
b. then red/purple flashing
c. then solid purple
d. then solid red
e. then off (the device is rebooting) f. then yellow -> flashing -> solid (normal boot process)
The entire process will take approximately 10 minutes to complete.