You are here

NanoStation M5 XW won't save config

4 posts / 0 new
Last post
KC7ZDM
NanoStation M5 XW won't save config
Just successfully flashed a NanoStation M5 XW, change NOCALL-132-88-175 to KC7ZDM-NANOSTN-06, enter the password (twice), change the distance parameter, select the 13 host direct option, click Save Changes and the page instantly goes away and displays This site can't be reached. The node does not reboot. When I go back to access localnode:8080 all the parameters are back the way they were.

Any ideas on what's happening? This is the factory edition, haven't had a chance to upgrade yet. The firmware I applied was AREDN-3.16.1.1-ubnt-nano-m-xw-squashfs-factory.bin.

FYI, I did run the U-Boot utility first got a Bad/Good result, backed it up, downgraded to XW.v5.5.10-u2.28005.150723.1358.bin successfully, re-ran U-Boot and got a Good/Good result. No issues with flashing the firmware up until I thought I was home free entering my call, etc.
 
AE6XE
AE6XE's picture
This was happening to me for
This was happening to me for some reason.  I changed from chrome to IE browser and it worked...
KC7ZDM
Well that's just weird and oh
Well that's just weird and oh so wrong! I switched to IE and it worked. I had flashed a Rocket an hour earlier in Chrome, the best browser on the planet, and it worked fine. Who woulda thunk that Internet Expoder would work when Chrome didn't!

Thanks!
AE6XE
AE6XE's picture
This might be the situation
This might be the situation where chrome is trying to be too smart and cache data coming over from the prior node you setup.  I was reinstalling images on a couple of nodes and cycling through a few times too.

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer