I am having an issue trying to install the AREDN FW on a PowerBeam 5AC Gen2 that is on the stock Ubiquiti FW v 8.7.0 build 42152. The radio is connected through a stand alone switch and seen at 192.168.1.20 as expected. I can access the Ubiquiti setup at that address. When I power it up while holding the reset button, I also get the flashing 1-3, 2-4 LEDs as expected. I am using tftp under windows:
tftp.exe -i 192.168.1.20 put C:\temp\aredn-3.25.10.0-ath79-generic-ubnt_powerbeam-5ac-gen2-squashfs-factory.bin
When I execute the command, I can see the <-> arrow flashing on the radio indicating some kind of communication, but then it eventually goes back to flashing 1-3, 2-4 and never reboots. Upon a hard power down/up, I again get the stock Ubiquiti page so the FW has not been installed.
Any ideas or other things I can try? I also tried installing the nightly build with the same result.
73 de Bud
W0RMT
tftp.exe -i 192.168.1.20 put C:\temp\aredn-3.25.10.0-ath79-generic-ubnt_powerbeam-5ac-gen2-squashfs-factory.bin
When I execute the command, I can see the <-> arrow flashing on the radio indicating some kind of communication, but then it eventually goes back to flashing 1-3, 2-4 and never reboots. Upon a hard power down/up, I again get the stock Ubiquiti page so the FW has not been installed.
Any ideas or other things I can try? I also tried installing the nightly build with the same result.
73 de Bud
W0RMT