I have the latest firmware. I am seeing under status, Blocked- signal. What does that tell me? I read the manual, but I am still a bit confused.
Refresh Quit |
10.144.12.212RF6--blocked - signal
k6dlc-rwc-2ghzDtD-0.0 miles100%active
|
/help.html#lqmstatus
...
blocked - signal: the SNR on the link is too low to reliably pass data, based on the LQM Min SNR setting.
...
Dan, you can drop the minimium SNR required under Basic Setup. The default is the minimum recommended by AREDN for decent performance.
Orv W6BI