You are here

Home » Forums » Development » General

Error in documentation Release 3.19.3.0

5 posts / 0 new
Log in or register to post comments
Last post
Thu, 07/04/2019 - 05:07
#1
LA9UI
Error in documentation Release 3.19.3.0
In the documentation (.PDF) 8.1 Basic Setup and 8.1.1 Mesh RF Column there is an error. Under active settings it says: '0' is auto. That is not correct for R 3.19.3.0. The distance must be 1 km or more to be allowed to save changes. Seems that auto-distance is no longer valid.

Hans-Petter  LA9UI
Top
Thu, 07/04/2019 - 09:53
AB7PA
Doc "latest" vs. other versions
LA9UI, In ReadTheDocs you have access to several different versions of the documentation.  The "Latest" version includes some features that may be part of the nightly builds, such as the auto-distance feature.  But the 3.19.3.0 version does not have the auto-distance feature since it was not yet available.  You can switch doc versions by clicking on the ReadTheDocs menu bar in the lower left corner of the display (screenshot).
 
Image Attachments: 
Top
Thu, 07/04/2019 - 10:16
AB7PA
Select docs version from arednmesh.org menu
You can also select different docs version by clicking on the aredenmesh.org Docs menu item and choosing the version of the documentation you want to view. (screenshot)
Image Attachments: 
Top
Thu, 07/04/2019 - 10:59
LA9UI
Dokumentation
Does that mean that "0" is auto is a new feature??

I am new to AREDN and have never been on older versions than 3.19.3.0

Hans-Petter  LA9UI
Top
Thu, 07/04/2019 - 11:12
(Reply to #4)
AB7PA
Auto-distance feature in Nightly Build versions
Hans-Petter, most people install the Stable firmware on their devices, and currently that is version 3.19.3.0 which is probably what you want to have on your devices.  Some operators install Nightly Build firmware in order to test new features.  You can see what new features are in the Nightly Build software by going to the arednmesh.org website and selecting Software > Nightly Builds > "The CHANGELOG file is here".  The ChangeLog file shows all of the individual features that have been added since the last Stable release of the firmware.  Right now, about halfway down the list, you'll notice that "autodistance setting option" was added on May 3, 2019.  I hope this helps.  THX
Top

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer