You are here

NanoBeamM5 19

3 posts / 0 new
Last post
VE7TFM
VE7TFM's picture
NanoBeamM5 19

I have a couple NanoBeamM5 19 with v5.5.9(xw)

I would like to use these as Nodes.

The supported hardware matrix points to the ubnt-loco-m-xw firmware.

I tftp the firmware,  it reboots as normal,  log-in to localnode:8080,  set node name and password as usual,  save the changes.

here it goes south.  the node doesn't reboot.  I still get a 192.168.1.24 ip address from the node and it comes back an an un-configured node.

where do I go from here?

Help!

K6AH
K6AH's picture
Disconnect your Ethernet

Disconnect your Ethernet cable from the PC, close all instances of the browser, reconnect and re-open the browser.  I had this same thing happen to me a week ago.

VE7TFM
VE7TFM's picture
Yup,  That is the issue.
Yup,  That is the issue.

never seen that before.  All good now.

Thanks

Ted VE7TFM

Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer