Two brand newly configured 210v2 nodes see and play nice with each other.
Computer connected to switch can access either unit. Computer trying wifi connect gets: Can Not Connect to this Network.
What did I do wrong? It has to be a simple error.
73 de mike
Computer connected to switch can access either unit. Computer trying wifi connect gets: Can Not Connect to this Network.
What did I do wrong? It has to be a simple error.
73 de mike
PCs aren't going to connect via wifi to a mesh node unless you have setup a wifi access point specifically for that purpose.
Andre
I traded out (apparently bad ap) with new tplink set up and connected node2 with static ip, made dhcp reservation.
Connecting to both nodes, but only using node base ip. so if I want to connect with node name, what do I need to change?
again, thanks
73 de mike
Andre
node is connected to cisco switch. laptop is connected to switch. laptop gets 10. address from node. node name works.
connected to AP on the second node, and only the node 10. base addr works. AP is configured with static from dhcp pool on node.
so if I want to control remote node via wifi, is that correct?