Thinking I was going to save myself some time, I found the network config files on the AREDN site at https://www.arednmesh.org/content/network-switch-configuration-files and downloaded the 6 LAN, 1 Node, 1 WAN file for the Netgear GS108Ev3, and ordered a new switch.
Unfortunately the switch I received is a v4, not a v3, and the config file won't load.
Is there an easy way to translate the older v3 config file to work with the v4 (running firmware V1.0.1.9)?
Thanks,
-Dj
Unfortunately the switch I received is a v4, not a v3, and the config file won't load.
Is there an easy way to translate the older v3 config file to work with the v4 (running firmware V1.0.1.9)?
Thanks,
-Dj
Note that VLAN 2 is not defined in my setup. Since it isn't assigned to any ports, the newer firmware doesn't allow it to be created. I think this is fine since I only have one node thus no DTD traffic.
https://www.arednmesh.org/content/gs105e-3-lan-1-node-1-wan
-Dj